Open Source Robotics

A curated collection of high-quality open source robotics projects, tools, and software to propel the robotics community forward.

Slip Ring

  • Also called: Rotary Electrical Joint, Collector Ring, Electrical Slip Ring
  • Category: Actuation & drivetrain › Transmission
  • Tags: electrical, transmission, actuation, cable-robots

A rotating electrical connector that carries power or signals across a joint that turns continuously, without the cable winding up.

Definition

Slip Ring is an electromechanical connector that passes electrical power or signals between a stationary part and one that rotates without limit. Conductive rings on the rotating side stay in sliding contact with fixed brushes on the stationary side, so the circuit is maintained no matter how many turns the joint makes.

It exists to solve a problem every rotating joint eventually hits: a cable run across a turning axis winds up. Designs without a slip ring must either limit travel to slightly less than a full turn, unwind periodically, or route power some other way. That limit is invisible in a CAD model and painful in a finished machine, because it turns an elegant continuous-rotation design into one with software end stops and a homing routine.

The trade-offs are wear and noise. Brushes are a sliding contact, so they wear, add friction, and inject electrical noise that matters more for signals than for power — which is why many designs pass only power through the slip ring and keep data on a wireless or optical path. Current rating, number of separate circuits and rated rotational speed are the specifications that decide whether a given part fits.

Why it matters

Continuous rotation is one of the few things a robot joint can do that a human one cannot, and a slip ring is usually what buys it. Without one, a design either accepts a hard travel limit or spends real complexity on unwinding — and that decision propagates into the kinematics, the control software and the user experience. It is a small, cheap component whose absence reshapes a machine.

Key applications

  • Winch and spool assemblies where the cable itself carries power
  • Continuous-rotation lidar and radar turrets
  • Pan axes on camera gimbals and inspection heads
  • Rotary tables and positioners that must not unwind between cycles
  • Wind turbine and crane rotating joints passing power and sensor signals

In practice

Stringman's powerline anchor is a good example: a 22 mm two-line 5 A slip ring sits at the centre of the spool so 24 V reaches the gripper down a cable that is itself being wound in and out. The build guide has you solder a JST plug to the fixed end, thread the rotating end through the spool, and splice it to the power line with solder-seal connectors — the knot rather than the splice taking any load. Elsewhere the same component shows up in continuous-rotation lidar turrets, camera pan axes and cable robots.

Common misconceptions

  • A slip ring gives unlimited rotation for free — brushes wear, and rated life is counted in revolutions, so it is a consumable in high-cycle designs
  • Power and data can share one freely — sliding contact injects noise, so signal circuits often need separate rings, shielding, or a different path entirely
  • Any slip ring will do — current rating, circuit count and rated RPM all constrain the choice, and undersizing shows up as heating rather than an obvious failure
  • It is the only way across a rotating joint — rotary transformers and wireless power avoid contact entirely, at higher cost and complexity

Who should know this

  • Anyone designing a joint that must rotate more than one full turn
  • Builders of winches, spools and cable robots
  • Anyone whose cable harness winds up or snags during testing
  • Designers deciding whether power and signal can share a path
  • Anyone specifying continuous-rotation sensors such as spinning lidar

Related terms

  • Actuator
  • Encoder
  • Cycloidal Drive
  • Direct Drive

Videos

  • What is a slip ring?: What Make Art
  • Introduction to Slip Rings: Moog

Wikipedia

  • Slip ring

This website requires JavaScript to function properly. Please enable JavaScript to explore our collection of open source robotics projects.