Gear Ratio
- Also called: Reduction Ratio, Transmission Ratio, Speed Ratio
- Category: Actuation & drivetrain › Ratings
- Tags: gears, transmission, actuation, sizing
How many turns of the motor produce one turn of the output — the number that trades speed for torque and quietly decides most joint behaviour.
Definition
Gear Ratio is the ratio between input and output rotation in a transmission, written as 15:1 or 100:1. A 15:1 drive turns the motor fifteen times for one turn of the output, and in exchange multiplies torque roughly fifteen-fold, minus losses.
That much is arithmetic. What makes gear ratio worth understanding is everything else it decides. Reflected inertia — how heavy the motor feels when you push the output — rises with the square of the ratio, so doubling reduction makes a joint four times harder to backdrive. Output speed falls proportionally, which can matter more than torque for a walking robot. Backlash and compliance both accumulate per stage, so reaching a high ratio through several stages costs precision. And efficiency compounds: three stages at 90% each deliver 73%.
This is why ratio is the first number to look at in an actuator spec and the last one to change casually. Choosing 6:1 rather than 60:1 is not a small adjustment to the same design; it produces a fundamentally different machine, with different control strategies available to it.
Why it matters
Almost every complaint about a robot joint traces back to its gear ratio. Not enough torque, too slow, cannot be pushed by hand, cannot feel contact, wanders on reversal — all of these are ratio decisions wearing different clothes. It is also the number most often chosen by copying someone else's build without asking what they were optimising for, which is how projects end up with joints that are strong but blind and rigid when they needed compliant and quick.
Key applications
- Sizing an actuator against the torque and speed a joint actually needs
- Deciding whether a joint can be backdriven or must use a force sensor
- Comparing single-stage and multi-stage transmission designs
- Estimating output speed and cycle time from a motor's rated RPM
- Diagnosing why a joint is strong but slow, or fast but weak
In practice
Typical robotics figures: 6:1 to 10:1 for quasi-direct-drive legged joints where backdrivability matters most; 15:1 to 40:1 for a printed cycloidal stage in a hobby arm; 50:1 to 160:1 for industrial arm joints using strain-wave gears where precision and stiffness dominate. Multi-stage designs multiply — a 5:1 belt onto a 20:1 gearbox gives 100:1 overall — and each stage adds its own backlash, friction and loss, which is why a single high-ratio stage is often preferred over two cheap ones.
Common misconceptions
- Higher ratio simply means more torque — it also squares reflected inertia and destroys backdrivability, which is usually the bigger consequence
- Ratio and torque multiply exactly — losses mean real output torque is always below the arithmetic figure, and by more in multi-stage designs
- Two stages of 10:1 equal one stage of 100:1 — the same ratio arrives with double the backlash, more friction and lower efficiency
- You can raise the ratio later if the joint is weak — reduction changes speed, inertia and control strategy together, so it is a redesign rather than a swap
Who should know this
- Anyone sizing a motor and gearbox for a joint
- Builders whose joint is strong but too slow, or fast but too weak
- Anyone comparing actuator datasheets across designs
- Students learning the speed-torque trade at the heart of mechanism design
- Anyone copying an actuator design without knowing what it optimised for
Related terms
Videos
- Gears Explained - mechanical engineering: The Engineering Mindset
- How do Gear Ratios Work?: Concerning Reality