Assembly guide for oomwoo
Open-source DIY robot vacuum: 3D-printed, ROS2 + 2D LiDAR, fully local.
License
Apache-2.0
Assembly guide
1. Project status
oomwoo is at the design/RFC stage — full build instructions are not published yet.
1.1 Build instructions not yet available
- oomwoo is at the design/RFC stage; step-by-step build instructions do not exist yet.
- A complete zero-to-hero guide (source parts, print the chassis, assemble, flash firmware, bring up ROS2, first clean) arrives once the first BoM is validated (~mid-July 2026).
- To follow along now, contribute to a module RFC or run the ROS2 Gazebo simulation via the oomwoo-one and oomwoo-install repos.