Open Source Robotics

A curated collection of high-quality open source robotics projects, tools, and software to propel the robotics community forward.

Assembly guide for HapCompass

Open-hardware wearable haptic device for contact-rich robot teleoperation

License

MIT

Assembly guide

1. Mechanical Assembly

Assemble the rotor, shells, pulley and belt into the device body.

1.1 Attach bearings and inner shells to the rotor

Attach the two ball bearings and the two inner shells to the rotor.

  1. Attach the two ball bearings and the two inner shells to the rotor.

1.2 Attach the motor pulley to the servo

Attach the motor pulley to the servo motor using the short screws from the servo package.

  1. Attach the motor pulley to the servo motor using the short screws from the servo package.

1.3 Mount the servo to the shell

Pass the driving belt through the long slot in the shell, then mount the servo to the shell using the long screws from the servo package.

  1. Pass the driving belt through the long slot in the shell, then mount the servo to the shell using the long screws from the servo package.

1.4 (Optional) Install the O-rings

Install the two rubber O-rings onto the outer shells. Tweezers and a small amount of glue make this easier.

  1. Install the two rubber O-rings onto the outer shells. Tweezers and a small amount of glue make this easier.

1.5 Fit the belt

Fit the driving belt around the pulley and the rotor.

  1. Fit the driving belt around the pulley and the rotor.

1.6 Close the shells

Assemble the upper shell and the bottom shell together using the screws and nuts.

  1. Assemble the upper shell and the bottom shell together using the screws and nuts.

2. Electronic Assembly

Wire the LRA and servo to the amplifier and driver boards.

2.1 Extend the LRA wires

The wires on the Drake actuator (LRA) are very short as purchased; extend them by soldering on additional wire.

  1. The wires on the Drake actuator (LRA) are very short as purchased; extend them by soldering on additional wire.

2.2 Install the LRA into the rotor

Install the LRA into the rotor. The arrow indicates the direction of the pulling sensation produced by the asymmetric vibration.

  1. Install the LRA into the rotor. The arrow indicates the direction of the pulling sensation produced by the asymmetric vibration.

2.3 Connect the LRA to the amplifier

Connect the LRA wires to the right-channel output of the audio amplifier board, observing correct polarity. Connect the board to the PC's speaker output with a 3.5 mm audio cable and connect a 5 V power supply.

  1. Connect the LRA wires to the right-channel output of the audio amplifier board, observing correct polarity. Connect the board to the PC's speaker output with a 3.5 mm audio cable and connect a 5 V power supply.

2.4 Connect the servo to the driver board

Connect the servo to the driver board with the extended wires. Connect the board to the PC with a USB-C cable and connect a 5 V power supply.

  1. Connect the servo to the driver board with the extended wires. Connect the board to the PC with a USB-C cable and connect a 5 V power supply.

This website requires JavaScript to function properly. Please enable JavaScript to explore our collection of open source robotics projects.